Skip to content
Drain Cleaning Chicago(872) 465-4386

Hydro jetting

A cable punches a hole through a clog. A jet washes the whole inside of the pipe.

Top: a cable's spiral head cuts a channel through a blockage. Bottom: a jetting nozzle fires most of its water backwards, which drives it forward and scrubs the pipe wall as it is pulled back.

When jetting earns its keep

  • A kitchen line that clogs again a few months after each rodding: grease left on the pipe wall.
  • Fine root hair that a cable chops but leaves in place.
  • Sludge and sand settled along the bottom of a long, low-slope run.
  • Clearing the pipe before a camera inspection, so the camera can see the walls.

When to hold off

Jetting puts serious pressure on the pipe. A clay tile line with a missing piece, or a cast-iron drain rusted thin, can be made worse. A careful company runs a camera first on a pipe it has not seen, or at least rods it and looks at what comes back.

If the pipe is already broken, jetting just washes soil into it. The fix there is repair, not cleaning. See sewer line repair.

What the visit looks like

The jetter is a pump and a hose reel, sometimes on a trailer, sometimes a portable cart that comes into the basement. The hose goes in through a cleanout. Expect noise, a wet floor near the cleanout and the water off for the length of the job.

In a two-flat, the other unit needs to stop using water too, since the jet is running in the shared drain.

Questions to put to the company

  • Will you look at the pipe with a camera before or after jetting?
  • Which nozzle will you use for roots, and which for grease?
  • Is jetting charged separately from rodding if you start with a cable?

Water still standing in the tub or the floor drain?

Tell the person who answers which drains are slow, what comes up where, and whether it is a house, a two-flat or a condo. Ask how the visit is charged before anyone comes out. Call (872) 465-4386.

(872) 465-4386